The ect PC1 MK II eddy current instrument is designed to plug into an expansion slot of an IBM AT or compatible computer. Together with the software, the ect PC1 MKII is a fully functional single frequency eddy current instrument. All eddy current instrument functions are under computer control. You may write your own software to control your test, using subroutines from our software for easy control of the eddy current instrument.

Features Frequency range 55 Hz to 4 Mhz. Auxiliary digital inputs and outputs. Wide bandwidth of 250 Hz suitable for high speed tubing inspection. Built-in angle amplifier. Stores and recalls all instrument settings. Save and recall calibration signals. Separate horizontal and vertical gain controls. Impedance plane or strip chart display. High resolution 16 bit digital balance.

Options Storage of eddy current data on internal hard disk or floppy disk. Analysis software for tubing inspection. Massive data storage on internal optical disk. Sold with or without the host computer. Up to four ect PC1 MKII channels per computer.

Frequency Characteristics Range: 55 Hz to 4 MHz Drift: Crystal Controlled Repeatability: Crystal Controlled Analog Output Characteristics Channels: Horizontal and Vertical Voltage: +8 Volts Bandwidth: Adjustable 10 Hz to 250 Hz Impedance: 100 k ohm Digital Output Characteristics Channels: 4 HCMOS TTL Analog Input Characteristics Channels: Horizontal and Vertical Voltage: +8 Volts Bandwidth: Adjustable 10 Hz to 250 Hz Impedance: 100 k ohm Digital Input Characteristics Channels: 4 HCMOS TTL Connectors Probe: D9S (MS 4-Pin Adapters are Supplied) System: D15S Transfer Characteristics Sensitivity: 100 volts/ohm Gain: 84 db at Maximum Gain Setting Balance: High Speed Digital Electronic

Controls (Keyboard Actuated) Frequency: 55 Hz to 4 MHz Gain: 0-255 Phase:0-360 Balance Erase Angle Amplification Horizontal Gain Vertical Gain Low Pass Filter Flaw Gate Remote Control Balance Erase Probe Types Differential Absolute Send/Receive